But doing so would add complexity, and thus remove many of the advantages of using WireGuard in the first place. This last issue could be resolved by using a more traditional public-key cryptosystem such RSA to distribute keys. It has not yet been properly audited for security issues, and the lack of a secure key sharing system across servers prevents widespread commercial roll-out at this time. WireGuard, therefore, has great potential, but it is still very much at the experimental and developmental stages. The brevity of the code also makes it easy to audit, and because it uses proven cryptographic primitives, it should be very secure. It is extremely lightweight (at just 3782 lines of code), which makes it much faster than traditional VPN protocols such as OpenVPN and IPsec. You’ll notice some differences due to my environment – use this as reference.WireGuard is an experimental VPN protocol that is generating a fair amount of excitement in the VPN world. See the screenshots below for my actual Unraid config. Varies, watch this YouTube video for help. Just be sure to choose a WireGard endpoint.įor tunnel traffic be sure to select Only IPv4.ĭownload your config Step 2: Setup your container as follows: Parameter I used Netherlands nl3-wireguard for this example. You may choose any location and any wireguard endpoint. Head over to your account page, and select Downloads > WireGuard configuration. Step 1: Generate key and download config from Mullvad However, I’ll admit that I only tested it with binhex/arch-sabnzbdvpn. Theretically these intructions shuold work for all of the following containers. This article is meant to be a more SEO friendly version of this post by u/ShaKsKreedz. Setting this up was a little frustrating for me, but in the end I found a VERY helpful Reddit post.

Mullvad wireguard config